The DAC is an advanced CMOS/Si-Cr 8-bit multiplying. DAC designed to interface directly with the , ,. , Z80®, and other popular. DAC DAC – 8-bit Microprocessor Compatible, Double-buffered D/A Converter, Package: Mdip, Pin Nb= The is an advanced CMOS/Si-Cr 8-bit. DAC Technical Data, DAC 8-bit D/A Convertor Datasheet, buy DACLCN.
|Published (Last):||1 November 2017|
|PDF File Size:||10.76 Mb|
|ePub File Size:||15.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
DAC Technical Data
The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors. This analog signal is the current quantity that is directly proportional to the input digital value and this current parameter needed to be converted in to voltage parameter for further use.
All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value.
DAC Datasheet(PDF) – National Semiconductor (TI)
Pin Configuration DAC is a datassheet pin device and description for each pin is given below. The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved.
Submitted by admin on 21 November This op-amp circuit is called current-to-voltage converter. The design also includes special circuitry that provides TTL logic input voltage level compatibility.
datasheey The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors. Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word.
TL — Programmable Reference Voltage. DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0.
Now for understanding the working let us consider the example application circuit given in the datasheet. This also permits the simultaneous updating of any number of DACs.
For working of device DAC we have connected a voltage source of 15V as shown in diagram.
So to convert the current parameter in datashete voltage parameter we will use op-amp circuit as shown in circuit diagram. DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output. So the device is used for converting 8 bit parallel digital data input to analog signal output.
We can use the circuit to develop applications without worry as the circuit is tested working. The device is available in the market for low cost and can be easily worked with.